Disk-Drive Cage; Removing The Disk-Drive Cage - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual

Steps
1. Align the mounting points on the carrier with the slots on the hard drive.
2. Slide the hard drive into the hard-drive carrier.
3. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive
cage.
4. Connect the data and power cables to the connectors on the hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in

Disk-drive cage

Removing the disk-drive cage

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
About this task
The following image indicates the location of the disk-drive cage and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
if applicable.
if applicable.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 49