Vga Module - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor Plus 7010:
- Owner's manual (126 pages) ,
- Technical manualbook (42 pages) ,
- Re-imaging manual (17 pages)
Table of Contents
Advertisement
VGA module
Removing the VGA module
Prerequisites
1. Follow the procedure in
Before working inside your
computer.
2. Remove the
side
cover.
About this task
The following image indicates the location of the VGA module and provides a visual representation of the removal procedure.
Steps
1. Remove the two (M2x5) cross-type screws that secure the VGA module to the chassis.
2. Disconnect the VGA-module cable from the connector on the system board.
3. Lift the VGA module off the system board.
Installing the VGA module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the VGA module and provides a visual representation of the installation procedure.
94
Removing and installing Field Replaceable Units (FRUs)
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex Small Form Factor Plus 7010 and is the answer not in the manual?
Questions and answers