Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual page 71

Steps
1. Align the screw holes on the media-card reader with the screw holes on the system board and chassis.
2. Connect the media-card reader to the connector on the system board.
3. Replace the two screws (M3x5) that secure the media-card reader bracket to the system board and the chassis.
4. Route the power-supply cables through the routing guides on the media-card reader bracket.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive
3. Install the 2.5-inch hard drive
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in
if applicable.
if applicable.
After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs) 71