Installing The Intrusion Switch - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor Plus 7010:
- Owner's manual (126 pages) ,
- Technical manualbook (42 pages) ,
- Re-imaging manual (17 pages)
Table of Contents
Advertisement
Steps
1. Remove the intrusion-switch cable from the routing guides on the chassis.
2. Disconnect the intrusion-switch cable from the connector on the system board.
3. Slide and lift the Intrusion switch away from the computer.
Installing the Intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Intrusion switch and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
75
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex Small Form Factor Plus 7010 and is the answer not in the manual?
Questions and answers