Disk-Drive Cage; Removing The Disk-Drive Cage - Dell OptiPlex Small Form Factor 7010 Owner's Manual

Steps
1. Slide the hard drive into the hard-drive carrier.
2. Replace the two screws (6-32) to secure the hard drive to the hard-drive carrier.
3. Align the tabs on the hard-drive carrier with the slots on the chassis and snap the hard-drive carrier onto the disk-drive
cage.
4. Replace the two screws (6-32) to secure the hard drive carrier on the chassis.
5. Connect the data and power cables to the connectors on the hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in

Disk-drive cage

Removing the disk-drive cage

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
After working inside your
Before working inside your
if applicable.
if applicable.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 47