System Board; Removing The System Board - Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual

Steps
1. Using a screwdriver, remove the Type-C module cover from the chassis.
NOTE: This step is applicable only when the Type-C module is being installed for the first time.
2. Connect the Type-C-module cables to their connectors (VIDEO and TYPE-C) on the system board.
3. Insert the Type-C module into the slot on the chassis.
4. Replace the two (M3x3) screws that secure the Type-C module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in

System board

Removing the system board

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
7. Remove the Optional I/O
8. Remove the expansion
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
modules.
card.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 101