Dell OptiPlex Small Form Factor Plus 7010 Owner's Manual page 51

Steps
1. Place the disk-drive cage upside down on the chassis.
2. If the optical drive is installed, connect the data and power cable to the connectors on the optical drive.
3. Hold the disk-drive cage upright and align the mounting points on the disk-drive cage with the slots on the chassis.
4. Align the screw hole on the cage with the screw hole on the chassis.
5. Move the lock handle to lock the disk-drive cage in place.
6. If the optical drive is installed, route the power and data cables through the routing guide on the disk-drive cage.
Next steps
1. Install the 3.5-inch hard drive
2. Install the 2.5-inch hard drive
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in
if applicable.
if applicable.
After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs) 51