According To The Type Of Batteries (Wet Or Gel / Agm), Set The Machine - Viper 50000532 User Manual

USER MANUAL
4. If the setting complete to the battery option. Install the screws on control panel.
Battery charging
5. Charge the batteries. (See procedures in maintenance chapter).
CAUTION!
Cut off all the power of the machine before perform the following procedure!
Battery charger setting
6.
Remove the screws (A, B, C, Figure 4.1).
7. Remove the plastic plug covering the DIP switch (F), and find the sw1 (E, Figure 4.1).
8.
Set the switches as the table of (Figure 4.1).
9. Put the plastic plug back, install the screws (A, B, C, Figure 4.1) after setting completes.
ACCORDING TO THE TYPE OF BATTERIES (WET OR GEL / AGM), SET THE
MACHINE AS FOLLOWS:
NOTE
Regarding the factory setting, learn the battery
type from boot time display according to above
table
1.
Press both the buttons (A, Figure. 4.2) and (B) at the same
time, Insert the ignition key (D) and turn on the power, after
0.5 second, enter battery setting mode. LED display during
setting (C), Release the buttons.
2.
The mode can be shift from 0 to 5 by pressing button (B), or
shift from 5 to 0 by pressing button (A). After the bat-tery
mode setting is completed, turn off the power (D) and the
new setting of battery mode can be saved automatically.
3.
The battery type setting is completed.
Battery type/Battery
Mode
manufacturer
0 WET
1 GEL/AGM
2 DISCOVER
3 OPTIMA
4 EXIDE
5 FULLRIVER
Battery charging
curve
General WET curve
General GEL/AGM
curve
DISCOVER EV GEL
OPTIMA GEL
EXIDE GEL
FULLRIVER GEL
14
LED1 LED2
D
Figure 4.2
LED display during
setting (
C, Figure. 4.2
ENGLISH
LED3
C
B
A
Boot time display
)
LED1 blink
twice
LED2 blink
twice
LED3 blink
twice
Both LED1 and
LED2 blink
twice
Both LED1 and
LED3 blink
twice
Both LED2 and
LED3 blink
twice