Machine Set Up; Machine Installation; Uncrating Machine; Battery Connections - Viper Fang 32T Owner's Manual

MACHINE SET UP & INSTALLATION

UNCRATING MACHINE

Be sure and check packing carton for any damage.
Immediately report any damage to carrier. Check
contents of package to ensure that the following
items are included: Machine, batteries (x6),
squeegee assembly, battery charger and pad
drivers. (Batteries and charger may be on separate
skid)

BATTERY CONNECTIONS

The batteries and charger are shipped separately
and will need to be installed and connected as
shown in the diagram below.
: Batteries emit hydrogen gas.
Explosion or fire can result from hydrogen gas.
Keep sparks and open flames away! Keep
battery compartment open while charging.
1.Be sure the power switch is in the "off" position.
2. Open recovery tank to gain access to battery
compartment.
3. Carefully place the six batteries into the
compartment as shown in figure below. Place
the battery brace at the rear of the batteries.
4. Connect battery cables to posts in order as
shown in diagram below. (RED to POSITIVE
and BLACK to NEGATIVE)
5. Apply a coating or protective spray on the
cable connections to prevent battery corrosion.
DO NOT DROP THE BATTERIES INTO
COMPARTMENT!

MACHINE SET UP

PRE-OPERATION CHECKS
1. Sweep or dust mop the surface to be cleaned.
2. Check battery meter to make sure batteries are
fully charged. (SEE BATTERY CHARGING)
3. Ensure squeegee is properly installed.
4. Ensure that brush/pad is properly installed.
INSTALLING PAD DRIVERS OR BRUSHES
1. Ensure the machine is turned off.
2. Raise the brush head assembly off the floor by
pushing on the brush lift button on the control
console.
3. Slide back the viewing window panel on the
aluminum deck housing.
4. If using a pad driver, first attach the
appropriate pad to the bottom of the driver.
5. Slide the pad driver under the deck and look
through the viewing panel and line the three
lugs with the three holes in the drive motor
hub. Once in the holes, rotate the driver
toward the spring clip to lock the driver in
place
MOUNTING THE SQUEEGEE
1. Pull the squeegee lift lever to raise the
squeegee bracket up.
2. Loosen the two knobs on the squeegee and
slide the squeegee into the slots at the rear of
the squeegee bracket. (the wheels on the
squeegee point to the back)
3. Tighten the knobs securely.
4. Secure the vacuum hose on the pick-up tube
of the squeegee.
5