Machine Set Up; Machine Installation - Viper TP24TSCRUB Owner's Manual

MACHINE SET UP & INSTALLATION
UNCRATING MACHINE
Be sure and check packing carton for any
damage. Immediately report any damage to
carrier. Check contents of package to ensure that
the following items are included: Machine,
batteries (x2), squeegee assembly, battery
charger, and pad driver.
BATTERY CONNECTIONS
The batteries and charger are shipped separately
and will need to be installed and connected as
shown in the diagram below.
Batteries emit hydrogen
gas. Explosion or fire can
result from hydrogen gas. Keep sparks and
open flames away! Keep battery
compartment open when charging.
1. Be sure power switch is in the "off" position.
2. Open recovery tank to gain access to battery
compartment.
3. Carefully place the two batteries into the
compartment as shown in figure below. Place
the battery brace at the rear of the two
batteries.
DO NOT DROP BATTERIES INTO
COMPARTMENT!
4. Connect battery cables to posts in numbered
order as shown in drawing below. (RED to
POSITIVE and BLACK to NEGATIVE)
R E D
B L A C K
C H A R G E R P L U G
5. Apply a coat or protective spray on the cable
connections to prevent battery corrosion.
B A T T E R Y B R A C E

MACHINE SET UP

PRE-OPERATION CHECKS
1. Sweep or dust mop the surface to be cleaned.
2. Check battery meter to make sure batteries
are fully charged. (see BATTERY CHARGING)
3. Check that squeegee is properly installed.
4. Check that brush / pad is properly installed.
INSTALLING PAD DRIVER OR BRUSH
1. Ensure that the machine is turned off
2. Raise the brush head assembly off the floor
by pushing on the brush lift button on the
control console.
3. Open the swing away skirts to gain access to
the brush head assembly.
4. If using a pad driver, first attach the
appropriate pad to the pad driver surface.
5. Mount the pad driver or brush to the drive
motor hub by lining up the three studs with
the three holes in the drive motor hub. Once
in the holes, rotate the driver toward the
spring clip to lock driver into place.
MOUNTING THE SQUEEGEE
1. Pull back on the squeegee lift lever to raise
the squeegee bracket up.
2. Loosen the two knobs on the squeegee and
slide the squeegee into the slots at the rear
of the squeegee bracket. (the wheels on the
squeegee point to the back)
3. Tighten the knobs securely.
4. Secure the vacuum hose on the pick-up tube
of the squeegee.
FILLING THE SOLUTION TANK
1. The 4NEL8 can be filled in two different
locations:
a. Front fill area for use with a hose or a
bucket.
b. Rear fill area for use with a hose only.
2. Determine which fill area you would like to
use to fill the machine with water.
5