Table of Contents
Advertisement
USER MANUAL
Battery charging with battery charger installed on
the machine
7.
Connect the battery charger cable (A, Figure 15) to the
electrical mains (G) (the electrical mains voltage and
frequency must be compatible with the battery charger
values shown on the machine serial number plate (F).
When the battery charger is connected to the electrical
mains, all machine functions are automatically cut off. If
the red warning light (B) on the battery charger control
panel stays on, the battery charger is charging the batteries.
8.
When the green warning light (C) turns on, the battery
charging is completed.
9.
When the battery charging is completed, disconnect the
battery charger cable (A) from the electrical mains (G) and
wind it round its housing (D).
10. Carefully lower the tank.
NOTE
For further information about the operation of
the battery charger (E, Figure 15), see the
relevant Manual.
BRUSH/PAD CLEANING
CAUTION!
It is advisable to use protective gloves when cleaning the brush/pad because there may be sharp
debris.
1.
Remove the brush/pad from the machine, as shown in the Use chapter.
2.
Clean and wash the brush/pad with water and detergent.
3.
Check that the brushes/pads are in working condition and not excessively worn; if necessary replace them.
SOLUTION FILTER CLEANING
1.
Drive the machine on a level floor.
2.
Ensure that the machine is off and the ignition key (35) has
been removed.
3.
Emptying the solution tank (Advice).
4.
Remove the transparent cover (D, Figure 16), then remove
the filter strainer (E). Clean and install them on the support
(F).
NOTE
The filter strainer (E) must be correctly
positioned on the housing (H) of the support
(F).
F
E
VACUUM TRACTION
F
G
E
D
22
ENGLISH
C
B
BRUSH
Figure 15
H
E
Figure 16
D
A
G
Advertisement
Table of Contents
