Machine Set Up; Machine Installation - Viper TP24TSCRUB Owner's Manual

MACHINE SET UP & INSTALLATION
UNCRATING MACHINE
Be sure and check packing carton for any
damage. Immediately report any damage to
carrier. Check contents of package to ensure that
the following items are included: Machine,
batteries (x2), squeegee assembly, battery
charger, and pad driver.
BATTERY CONNECTIONS
The batteries and charger are shipped separately
and will need to be installed and connected as
shown in the diagram below.
Batteries emit hydrogen
gas. Explosion or fire can
result from hydrogen gas. Keep sparks and
open flames away! Keep battery
compartment open when charging.
1. Be sure power switch is in the "off" position.
2. Open recovery tank to gain access to battery
compartment.
3. Carefully place the two batteries into the
compartment as shown in figure below. Place
the battery brace at the rear of the two
batteries.
DO NOT DROP BATTERIES INTO
COMPARTMENT!
4. Connect battery cables to posts in numbered
order as shown in drawing below. (RED to
POSITIVE and BLACK to NEGATIVE)
R E D
B L A C K
B A T T E R Y B R A C E
C H A R G E R P L U G
5. Apply a coat or protective spray on the cable
connections to prevent battery corrosion.
All manuals and user guides at all-guides.com
1. Sweep or dust mop the surface to be cleaned.
2. Check battery meter to make sure batteries
3. Check that squeegee is properly installed.
4. Check that brush / pad is properly installed.
1. Ensure that the machine is turned off
2. Raise the brush head assembly off the floor
3. Open the swing away skirts to gain access to
4. If using a pad driver, first attach the
5. Mount the pad driver or brush to the drive
1. Pull back on the squeegee lift lever to raise
2. Loosen the two knobs on the squeegee and
3. Tighten the knobs securely.
4. Secure the vacuum hose on the pick-up tube
1. The 4NEL8 can be filled in two different
2. Determine which fill area you would like to
5

MACHINE SET UP

PRE-OPERATION CHECKS
are fully charged. (see BATTERY CHARGING)
INSTALLING PAD DRIVER OR BRUSH
by pushing on the brush lift button on the
control console.
the brush head assembly.
appropriate pad to the pad driver surface.
motor hub by lining up the three studs with
the three holes in the drive motor hub. Once
in the holes, rotate the driver toward the
spring clip to lock driver into place.
MOUNTING THE SQUEEGEE
the squeegee bracket up.
slide the squeegee into the slots at the rear
of the squeegee bracket. (the wheels on the
squeegee point to the back)
of the squeegee.
FILLING THE SOLUTION TANK
locations:
a. Front fill area for use with a hose or a
bucket.
b. Rear fill area for use with a hose only.
use to fill the machine with water.