Restoring Saved Parameters; Uploading Saved Parameters To Other Power Managers - Black Box PS568A User Manual

RACKMOUNT REMOTE POWER MANAGERS

6.2 Restoring Saved Parameters

This section describes the procedure for using your communications program to
send saved parameters to the power manager.
Parameters saved to an ASCII file can only be restored via the text
interface. This procedure cannot be performed via the Web browser
interface.
1. Start the communications program on your local or remote PC and access the
power manager's command mode via the text interface as described in
Section 4.2.2.
2. If the password prompt is displayed, type in your system level password and
press Enter.
3. Configure your communications program to upload an ASCII text file.
4. Upload the file with the saved parameters. If necessary, type in the file name
and directory path.
5. When the upload is complete, make sure you terminate the communications
program's upload mode.
When the configuration file is sent to the power manager via Telnet, the
unit's IP address, subnet mask, and gateway address will not be
changed until after you exit from command mode.
At this point, saved parameters should have been restored to the power manager.
Check the Plug Status screen, General Parameters menu, Plug Parameters menu,
and Network Parameters menu to make certain that saved parameters have been
accurately restored.

6.3 Uploading Saved Parameters to Other Power Managers

To upload saved parameters to other power managers, follow the
procedures listed in Section 6.2.
48
NOTE
NOTE
NOTE