Front Panel - Black Box PS568A User Manual

RACKMOUNT REMOTE POWER MANAGERS
Table 2-1 (continued). Back-panel components.
Component
❺
Default button (continued)
❻
Unit status indicators
❼
Network port and activity
indicator
❽
Master power switch
❾
COM/RS-232 port
2.2.2 F P
RONT ANEL
The Rackmount Remote Power Manager's front panel has two indicators. Located
from left to right are LEDs for Power On and Sys Rdy (flashes when the system is
ready).
12
Description
Manual plug toggle: Press the default button and
and hold it down for three seconds. All power
outlets will be toggled on or off.
These two LEDs function as follows:
ON: Lights when power is applied to the power
manager.
RDY: Flashes continuously when the power
manager is ready to receive commands.
An RJ-45 Ethernet port for connection to your
TCP/IP network. The default IP address is
192.168.168.168. For more information, refer to
Section 4.3.4. The Activity LED flashes to
indicate activity at the network port.
This switch turns on the power manager itself.
The switch must be on for the power manager to
function. This switch is not used to set the on/off
status of the switched outlets.
This DB9, RS-232 (DTE) serial port connects to
a local terminal or external modem, as described
in Section 3.3.