► Error Code
H2–6744
► Error message
Staple Cartridge not install. Install it.
► Symptom
Finisher stapler cartridge is not installed into stapler.
► Troubleshooting method
1) Open finisher stapler door to put cartridge into stapler and then close door. Self-Priming will be execute
automatically if necessary.
2) If stapler warning does not disappear, follow the instructions below :
a) Does finisher stapler input sensor work well?
i) Make sure finisher input sensor cable is connected well to the sensor connector.
ii) Make sure finisher input sensor cable is connected well to the main board connector.
iii) Replace the finisher stapler cartridge(JC81–08653A).
iv) Replace the finisher stapler(JC81–07376A).
v) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
b) Check if any debris is present. Please make sure to remove any debris.
Copyright© 1995-2016 SAMSUNG. All rights reserved.
4. Troubleshooting
4-142