Troubleshooting - Beef Eater SIGNATURE BSB2040BA Assembly And Operating Instructions Manual

TROUBLESHOOTING

PROBLEM
Barbecue will not light
Barbecue lights but goes out
soon after starting
Burners will not cross light from one
to the other
Low flame level or low heat output
Gas Consumption
LPG
4 Burners
5 Burners
NG
4 Burners
5 Burners
CAUSE
Ignition system not working
Turning on gas control too quickly
No gas flow
Burners not assembled correctly
Burner ports or throat blocked
Fuel supply turned off
Gas cylinder low or empty
Kink in gas hose
Wind or breeze affecting operation
Burners will not cross light
BTU/hr MJ/hr
64,451 68
80,564 85
BTU/hr MJ/hr
64,451 68
80,564 85
CHECK
Check to see visible spark at starter probe
- if no spark is present when control knob
is turned then the unit may need to
be serviced or replaced. Contact your
BeefEater dealer.
Check that there is a visible flame coming
from the pilot ignition tube.
Check that the pilot ignition tube is not
blocked by spider webs or insect nests.
Allow at least 5 seconds for gas to flow
through burner before ignition.
Check that valve on gas cylinder is turned
on.
Check that burner ports are free of
obstructions.
Check that all gas injectors are clean and
free of obstructions.
Check that burners are correctly positioned
in the barbecue frame.
Check that the burner ports are not
blocked by spider webs or insect nests.
Clean out as required.
Turn on gas valve at cylinder.
Replace cylinder and carry out a leak check.
Check that the gas line is not kinked or
twisted.
Ensure that the appliance is located out of
the way of wind.
Check that cross light channel is in place.
Check that burner ports are free of
obstructions.
Check you are running on correct gas
Check gas injector size is correct.
kW g/hr
18.89 1,371
23.62 17,714
kW
18.89
23.62
TROUBLESHOOTING
21