Mounting Enclosure Guidelines - Beef Eater SIGNATURE BSB2040BA Assembly And Operating Instructions Manual

MOUNTING ENCLOSURE GUIDELINES

Mounting enclosure (gas bottle compartment adjacent)
Barbecue
venting slots
Low level Gas bottle compartment
venting venting slots
Enclosure construction
• All materials used for the construction of the enclosure
and gas bottle compartment must be non-combustible.
• A 40mm min. gap between the enclosure and rear wall
is required. This allows for venting of both the barbecue
and gas bottle compartment. Vents should also be
positioned at the front of the enclosure.
• The appliance can be supported by either hanging from
the benchtop (hanging brackets supplied) or sitting
the appliance on a support frame that is built in to the
enclosure.
Mounting enclosure (gas bottle compartment underneath)
Barbecue
venting slots
Gas bottle compartment
venting slots
828mm 4 burner
1006mm 5 burner
793mm 4 burner
971mm 5 burner
Rear wall / splashback
to be non-combustible
material
Enclosure ventilation requirements
EN 498:2012 & EN484:2017
9kg cylinder storage are:
•
•
828mm 4 burner
1006mm 5 burner
100mm min.
793mm 4 burner
971mm 5 burner
Rear wall / splashback
to be non-combustible
material
630mm min.
40mm
min. gap
520mm
ventilation requirements for
Where of sheet metal or similar impervious construction
there shall be ventilation openings at the top and bottom
of the enclosure or recess, each opening providing a
free area of at least 200cm for every cylinder enclosed.
2
For LPG installations having enclosed cabinetry below
the separation panel that does not contain a gas bottle,
low level venting must be installed. This is to allow
the gas which is heavier than air to escape from the
enclosure in the situation where there may be a leak.
A minimum opening of 200cm is required.
2
630mm min.
40mm
gap
520mm
MOUNTING ENCLOSURE GUIDELINES
Support frame for
barbecue base
Gas bottle
compartment
venting slots
Support frame for
barbecue base
Gas bottle
compartment
venting slots
13