Troubleshooting - Beef Eater 1600 Series Assembly And Operating Instructions Manual

NOTES

TROUBLESHOOTING

PROBLEM
Barbecue will not light
Barbecue lights but goes out soon
after starting
Burners will not cross light from one
to the other
Low flame level or low heat output
CAUSE
Ignition system not working
Turning on gas control too quickly
No gas flow
Burners not assembled correctly
Burner ports or throat blocked
Fuel supply turned off
Gas cylinder low or empty
Kink in gas hose
Wind or breeze affecting operation
Burners will not cross light
CHECK
Check to see visible spark at starter
probe - if no spark is present when
control knob is turned then the unit may
need to be serviced or replaced. Contact
your BeefEater dealer.
Check that there is a visible flame coming
from the pilot ignition tube.
Check that the pilot ignition tube is not
blocked by spider webs or insect nests.
Allow at least 5 seconds for gas to flow
through burner before ignition.
Check that valve on gas cylinder is
turned on.
Check that burner ports are free of
obstructions.
Check that all gas injectors are clean and
free of obstructions.
Check that burners are correctly
positioned in the barbecue frame.
Check that the burner ports are not
blocked by spider webs or insect nests.
Clean out as required.
Turn on gas valve at cylinder.
Replace cylinder and carry out a leak
check.
Check that the gas line is not kinked or
twisted.
Ensure that the appliance is located out of
the way of wind.
Check that cross light channel is in place.
Check that burner ports are free of
obstructions.
Check you are running on correct gas
Check gas injector size is correct.
TROUBLESHOOTING
33