Related Manuals for Beef Eater BUGG BB18224
Summary of Contents for Beef Eater BUGG BB18224
- Page 1 BUGG BB18224, BB18226, BB18228, BB18225GA Assembly and Operating Instructions AUSTRALIA / NEW ZEALAND FOR OUTDOOR USE ONLY...
-
Page 2: Table Of Contents
CONGRATULATIONS CONTENTS Dear customer, Important safety instructions ............3 Product description ..............4 Congratulations and thank you for choosing our barbecue. Dimensions .................. 5 We are sure you will find it a pleasure to use. Before you use the barbecue, we recommend that you read through the Product description for stand ............6 relevant sections of this manual, which provide a description Assembling the barbecue ............ -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Please read the user manual carefully and store in a handy place for later reference. WARNING WARNING • Do not lean over barbecue when lighting. • Do not leave the barbecue unattended when alight. IMPORTANT TIPS & INFORMATION •... -
Page 4: Product Description
PRODUCT DESCRIPTION Barbecue body Hood Operating Knobs R + L Stand * Locking U Bolt Cylinder Hook Utility Hook Cylinder Shield* Shelves Grill and Plate Burner Hood Handle Body handle Thermometer ** Grease Tray * Stand is sold separately ** May not be included with all models PRODUCT DESCRIPTION... -
Page 5: Dimensions
DIMENSIONS 554 (22”) 580 (23”) 702 ( 27 1 /2 ”) 592 ( 23 1 /4 ”) 1088 (43”) Barbecue manifold inlet thread: 3/8 SAE male flare fitting. WARNING CAUTION Note: Do not modify this appliance. Gas Pressure: Any deviation from factory settings could result LPG –... -
Page 6: Product Description For Stand
PRODUCT DESCRIPTION FOR STAND INDEX DESCRIPTION QUANTITY FASTENERS Screw , 16mm (black) Top Connecting Panel Screw , 25mm (stainless Steel) Front Shelf Brackets 1R + 1L Spring Washer Wheel Bracket 1R + 1L Screw, 8mm Cylinder Hook Circlip Silicone Feet Plastic Washer Wire Shelf Alan Key... -
Page 7: Assembling The Barbecue
ASSEMBLING THE BARBECUE Assemble Front leg: [ 4 x A, 4 x B ] Place the Leg (1) on a padded flat, level surface and assemble the two Front Shelf Brackets (3). Insert two Silicone Feet (6) to the bottom hole, and pull until rest against bottom of leg. Assemble Back leg: [ 8 x A, 8 x B ] Place other Leg (1) on a padded flat, level surface and assemble the Wheel Brackets (4) and Cylinder Hook (5). -
Page 8: Wheel
ASSEMBLING THE BARBECUE Assemble Stand [ 8 x A, 8 x B ] Attach the Top Connecting Panel (2) with four screws to the Front Leg and four more screws to the Back leg: Assemble the wheels [2 x D] Wheels (8) are placed on the inside of brackets. -
Page 9: Wire Shelf
ASSEMBLING THE BARBECUE Fit the Wire Shelf [ 4 x A1, 4 x B] The Wire Shelf (7) has two plates, and two hooks. The hooks are facing forward, and will engage into the Front Shelf Brackets (3) assembled in step 1. The plates have two holes each through which screws go into Back Leg: Place the Cylinder Shield [ 6 x C, 6 x E ] The Cylinder Shield (11) is attached to the rear leg by six screws and washers, three each side. - Page 10 ASSEMBLING THE BARBECUE Position the Barbecue into Stand, and lock With the stand standing on a stable, flat surface, remove the Locking U Bolt from the rear of the Barbecue, and place the Barbecue onto the stand, ensuring each leg is fully engaged into the corresponding recess in the stand. Once the Barbecue is placed correctly over the stand, ensure the Grease-Tray is in its place under the Barbecue, and fully engage the Locking U Bolt back to its place.
-
Page 11: Gas Specifications
GAS SPECIFICATIONS Gas bottle installation GAS TYPE UNIVERSAL LPG NATURAL GAS Maximum gas 20 MJ/h 20 MJ/h • Connect the gas hose to the gas bottle. consumption • Place the gas bottle onto the cylinder hook at the rear Injector office 0.9 mm AU/NZ 1.83 mm of the barbecue. - Page 12 GAS SPECIFICATIONS Natural gas installation See below illustration NOTE: Conversion of this unit to natural gas must be carried Remove each gas injector from the end of each jet out by a qualified licensed pers on and a Certificate of holder, turning gently in a counter clockwise direction.
- Page 13 GAS SPECIFICATIONS Turn down adjustment Choosing a location • When converting to natural gas the turndown setting will • The vertical clearance above the cooking surface to any need to be adjusted to give a satisfactory flame on combustible materials must be at least 1000mm. low setting.
-
Page 14: Installation Warnings
INSTALLATION WARNINGS WARNING WARNING Outdoor area • This appliance shall only be used in an above ground, example 1 open air situation with natural ventilation without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind or natural convection. -
Page 15: Configuration Options
CONFIGURATION OPTIONS OPERATING INSTRUCTIONS WARNING IMPORTANT WARNING TIPS & INFORMATION Plate and grill can be positioned either on the left or right The use of two hotplates is not recommended. This configuration does not allow adequate ventilation for the side as shown. barbecue to operate safely. - Page 16 OPERATING INSTRUCTIONS Preheating WARNING WARNING • This barbecue is fitted with high power burners. In • Only use two burners on low setting with hood closed. most conditions it will only be necessary to preheat the Do not allow temperatures to exceed 260°C with hood barbecue for only a few minutes before cooking can closed as it may cause damage to the barbecue and commence.
-
Page 17: Cleaning And Care
CLEANING AND CARE Intensive cleaning cycle WARNING WARNING In instances when the cooking surface becomes heavily Please ensure that your barbecue is switched off and has soiled and harder to clean, the barbecue can be set-up for an cooled down before following the instructions below. intensive cleaning cycle. -
Page 18: Troubleshooting
TROUBLESHOOTING ACCESSORIES PROBLEM POSSIBLE CAUSE SOLUTION STANDARD INCLUSIONS Barbecue No gas Check isolation Cast iron hotplate won’t light valve is ON Cast iron grill Gas bottle empty – OPTIONAL EXTRAS* refill or change gas bottle Gas conversion kit – NG Ignition system not Check spark being Cast iron planchar plate... -
Page 19: Warranty
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: BEEFEATER BUGG BARBECUE This document sets out the terms and conditions of the product 7. You may not make a claim under this warranty unless the defect claimed is warranties for Electrolux Appliances. It is an important document. due to faulty or defective parts or workmanship. - Page 20 For more information on all Beefeater products, or for dimension and installation information, call into your retailer, phone or email our customer care team or visit our website: AUSTRALIA phone: 1300 307 939 fax: 1800 356 669 email: customercare@electrolux.com.au web: beefeaterbbq.com NEW ZEALAND phone: 0800 436 245...