NATURAL GAS INSTALLATION
NATURAL GAS INSTALLATION
W ARNING
WARNING
Conversion of this unit to natural gas must be carried out by
a qualified licensed person and a Certificate of Compliance
must be issued to the owner on completion of the installation
and conversion. Conversion of this barbecue by unlicensed
persons may result in improper functioning of the appliance,
injury, property damage and may affect your ability to make a
claim under the manufacturer's warranty.
Converting the unit to natural gas
This barbecue is set up for LPG and is labelled
accordingly. A natural gas conversion kit is available as an
accessory if required.
The components in the kit are:
•
6 x brass injectors (natural gas)
•
700mm hose with ½" male pipe thread at one end and
3/8" SAE Flare with 5/8-18 UNF female thread at the
other end
•
Natural gas regulator with ½" female pipe threads on
inlet and outlet
•
1500mm hose with ½" male pipe thread at one end and
quick connect at the other end
•
2000mm tether (mobile use only)
•
Natural gas sticker
1. Replace 'gas type' sticker
•
Locate LPG gas sticker located on the lower face of the
control panel and remove it. Put natural gas sticker in
its place
2. Change the injectors
•
Remove the burners and grease tray from the appliance
to gain access to the injectors
•
Unscrew the LPG injectors and replace with natural
gas injectors on all valves. All injectors are marked
with the orifice size
•
Do not overtighten injectors
10
NATURAL GAS INSTALLATION
3. Change the aeration shutter
•
Remove the burners from the appliance
•
Remove the locating screw from the aeration shutter
•
Slide the aeration shutter off the burner and then refit
using the Natural gas location hole
•
Repeat this procedure on all burners and then reinstall
back into the appliance
Locating screw
Natural gas
location hole
Remove LPG injector and
install injector for natural gas.