Troubleshooting - Beef Eater DISCOVERY 1000 Series Assembly And Operating Instructions Manual

TROUBLESHOOTING

Condition
Flame goes out while in use
Ignition failure
Foul smell of gas
Flame appear to separate off the
Burner or flame burns with noise
Yellow tipping in flame
Possible Cause
Empty gas cylinder
Air mixed in hoses
Blockage
Gas cylinder valve close
Air mixed in the hoses
Rubber hose wrapped, deformed
Or pinched
Spark escaping
No spark
Damage to hose
Leakage
Burner went off
Incorrect combustion
Blockage of burner ports
Air/gas mixture screw in burner
Incorrect
Solution
Replace cylinder
Re-ignite and allow operating for a
short while, till clears out
Seek professional assistance
Turn off knob button, then open the
cylinder valve
Re-ignite and allow operating for a
short while, till clears out
Foul smell of gas
Ensure the spark probe is in
Place, not deformed, clean
Seek professional assistance
Turn cylinder valve off, replace
Hose
Leak-test, and tighten where required.
If leakage can't be rectified, cease
using appliance, and seek professional
assistance
Shut off valves, wait for 5 minutes and
reignite
Seek professional assistance
Clean the burner thoroughly.
If problem persists, seek
Professional assistance
Try to open screw to remove
Yellow. If not changing, seek
Professional assistance
TROUBLESHOOTING
19