Mounting Enclosure Guideline - Beef Eater 1500 Series Assembly And Operating Instructions Manual

MOUNTING ENCLOSURE GUIDELINES
Mounting enclosure dimensions when installed with Beefeater hanging bracket BA70HS
Separation panel
Gas bottle
venting slots
Enclosure construction
• All materials used for the construction of the enclosure
and gas bottle compartment must be non-combustible.
• A 40mm min. gap between the enclosure and rear wall
is required. This allows for venting of the gas bottle
compartment. Vents should also be positioned at the
front of the enclosure.
• The cutout size specified above and below allow for
a 20mm gap between the back of the barbeque and
benchtop. This gap will help maintain air flow around
the barbeque.
• The cutout sizes specified above are for use with the
Beefeater hanging bracket BA70HS. This bracket is
purchased separately as an accessory.
• The cutout sizes specified below are for when the
product is installed without hanging brackets.
The product rests directly onto its base.
Mounting enclosure dimensions when installed without hanging brackets
Separation panel
Gas bottle
venting slots
12
MOUNTING ENCLOSURE GUIDELINES
730mm 3 burner
880mm 4 burner
1050mm 5 burner
Rear wall/splashback to be
non-combustible material
Enclosure ventilation requirements
AS5601 ventilation requirements for 9kg cylinder storage are:
•
•
Gas bottle size
•
680mm 3 burner
830mm 4 burner
1000mm 5 burner
Rear wall/splashback to be
non-combustible material
650mm min.
604mm
40mm
gap min.
Where of sheet metal or similar impervious construction
there shall be ventilation openings at the top and bottom
of the enclosure or recess, each opening providing a
free area of at least 200cm for every cylinder enclosed.
2
For LPG installations having enclosed cabinetry below
the separation panel that does not contain a gas bottle,
low level venting must be installed. This is to allow
the gas which is heavier than air to escape from the
enclosure in the situation where there may be a leak.
A minimum opening of 200cm
2
This appliance is designed to be used with a gas
cylinder not exceeding 9kg (20lbs) capacity. The overall
size of the gas bottle should not exceed 315mm in
diameter and 460mm in height.
650mm min.
604mm
40mm
gap min.
Gas bottle
venting slots
is required.
Gas bottle
venting slots