Table of Contents
Advertisement
20
model no. MPPH-06CRN1-BI0 | contact us: 1. 866.646.4332
.
.
.
.
Handling the remote controller
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
Do not recharge batteries or dispose of them in fire.
Battery disposal-please dispose the used battery per municipal or provincial law.
.
Location of the remote controller.
Keep the remote controller where its
signals can reach the receiver of the
.
unit (a distance of 8m is allowed).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15
minutes may occur.
Replacing batteries
The remote controller uses two
dry batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment off according to the
arrow direction, then replace the
old batteries with new ones.
(2) Insert the new batteries making
sure that the(+) and (-) of battery
are installed correctly.
(3) Reattach the cover by sliding it
.
back into position.
After replacing batteries, set the
remote controller clock.
containers to
protect the environment
Advertisement
Table of Contents
