Comfee MPPH-10CRN1-BI0 Instruction Manual page 11

Foam seal A
(adhesive type)
Fig.12
Window
panel
26.6"(67.5cm)~48.4"(123.0cm).
Fig. 13
Foam seal
Installation in a sliding sash window
1. Cut the foam seal A (adhesive type) to the proper
length and attach it to the window frame. See Fig.12.
2. Attach the window slider kit to the windowsill.
Adjust the length of the window slider kit according
to the width of window, shorten the adjustable window
kit if the width of window is less than 26.6 inches.
Open the window sash and place the window slider
kit on the windowsill. See Fig.13.
3. Cut the foam seal (adhesive type) to the proper
length and attach it on the top of the window kit .
See Fig.14.
4. Close the sliding sash securely against the window kit .
5. Cut the foam seal
appropriate length and seal the open gap
between the
outer window sash. See Fig.15.
Fig.14
(non-adhesive type)
Fig.15
to an
(non-adhesive type)
closed side window sash and
11