Table of Contents
Advertisement
Press the SET key to skip over a parameter to the next.
Absolute Pressure Calibration
In the calibration mode, the "ABS" symbol will display at the
pressure section, the absolute pressure value will flash. (The
default value is 0.00 inHg)
Press the CHANNEL/+ key or MAX/MIN/- key to increase or
decrease the absolute pressure value (in increments of 0.01
inHg).
Press and hold the CHANNEL/+ or MAX/MIN/- key for three
seconds to increase or decrease rapidly.
Press the ALARM key to reset current value.
Example: The calibrated pressure sources measure 28.37
inHg. The display console pressure reads 28.75 inHg.
Offset = 28.37 - 28.75 = - 0.38 inHg
Relative Pressure Calibration
In the calibration mode, press the SET key again, the "REL"
symbol will display at the pressure section, the relative
pressure value will flash. (The default value is 0.00 inHg)
Press the CHANNEL/+ key or MAX/MIN/- key to increase or
decrease the relative pressure value (in increments of 0.01
inHg).
Press and hold the CHANNEL/+ or MAX/MIN/- key for three
seconds to increase or decrease rapidly.
- 33 -
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SC089 and is the answer not in the manual?
Questions and answers
How do I reset the indoor temperature setting on my sainlogic sc089 weather station.
To reset the indoor temperature on the Sainlogic SC089 weather station, press and hold the MAX/MIN key for three seconds to clear all minimum and maximum values, including indoor temperature. After reset, the display will show the current values.
This answer is automatically generated