Table of Contents
Advertisement
3.4.3 Connect Sensors with Display Console
Once the display console is powered up, it will automatically
scan all the nearby Integrated Outdoor sensors.
Note: Do not press any button until all the remote sensors
report in the display screen, otherwise the display console will
terminate to connect with remote sensors.
Note: While in the search mode, the remote search icon
will be constantly displayed until all the measured values
received. The console will automatically switch to the normal
mode from which all further settings can be performed.
When connected with the Integrated Outdoor Sensor, the
measured value (Outdoor temperature, humidity, wind speed,
wind direction, wind gust and average, rainfall, UV and
Sunlight index, Dew point and feels like) will show up on the
display console.
Note: Make sure that the distance between weather station
sensors and display console should be within 10ft (3m) to 100ft
(30m). If the weather station sensors is too close or too far
away, it may not receive a proper signal.
3.5 Sensor Operation Verification
The following steps verify proper operation of the sensors prior
to installing the sensor array.
1. Verify proper operation of the rain gauge. Tip the
Integrated outdoor sensor back and forth several times. You
will heard a "ticking" sound within the rain gauge. Verify the
- 11 -
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SC089 and is the answer not in the manual?
Questions and answers
How do I reset the indoor temperature setting on my sainlogic sc089 weather station.
To reset the indoor temperature on the Sainlogic SC089 weather station, press and hold the MAX/MIN key for three seconds to clear all minimum and maximum values, including indoor temperature. After reset, the display will show the current values.
This answer is automatically generated