Table of Contents
Advertisement
When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the
image become dark or the color of the image become unnatural, replacement of the Lamp is required.
CAUTION
For continued safety, replace with a lamp assembly of the same type.
Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector
can become very hot.
Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
Turn off the projector and disconnect the AC plug. Allow the
1
projector to cool for at least 45 minutes.
Remove a screw with a screwdriver and remove the lamp cover.
2
Remove 2 screws with a screwdriver and pull out the lamp
3
assembly by grasping the handle.
Replace the lamp assembly.
4
5
Replace the Lamp Assembly and tighten 2 screws. Make sure
that the Lamp Assembly is set properly. And replace the Lamp
Cover and tighten a screw.
Connect the AC Power Cord to the projector and turn the projector
6
on.
Reset the Lamp Replacement Monitor Timer (refer to the section
7
"Lamp Replacement Monitor Timer" below.)
NOTE : Do not reset the LAMP REPLACEMENT
MONITOR TIMER, when the lamp is not replaced.
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp
Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting.
Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT
1
LEFT/RIGHT buttons to select SETTING
dialog box SETTING MENU Menu will appear.
Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to Lamp age, and then press the
2
SELECT button. The message of "Lamp replace monitor Reset?" is displayed.
Select [Yes] to reset the Timer.
3
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
Follow these steps to clean the projection lens:
1
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2
Lightly wipe the cleaning cloth over the lens.
When you don't use the projector, replace the lens cover.
3
LAMP REPLACEMENT Indicator
Lamp Replacement
Lamp Replacement Monitor Timer
and press the SELECT button (refer to the page 40). Another
Cleaning the Projection Lens
LAMP COVER
HANDLE
LAMP
ASSEMBLY
APPENDIX
43
Advertisement
Table of Contents
