Table of Contents
Advertisement
Lamp Replacement
When the projection lamp of the projector reaches its end of
life, the Lamp replacement icon appears on the screen and
LAMP REPLACE indicator lights yellow. Replace the lamp with
a new one promptly. The timing when the LAMP REPLACE
indicator should light is depending on the lamp mode.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of the
projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
2
Remove the screw and open the lamp cover.
3
Remove the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
4
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp counter.
See "Resetting the Lamp Counter" on the next page.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
Model No. of your projector
●
Replacement Lamp Type No.
●
Top Control
Lamp replacement icon
Note:
✔
• The Lamp replacement icon will not appear when the
Display function is set to "Off" (p.48), during "Freeze"
(p.28), or "No show" (p.29).
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Press here and pull upward.
Lamp Cover
Screw
: PLC-WXU30/PLC-WXU30K
: POA-LMP111
(Service Parts No. 610 333 9740)
Maintenance and Cleaning
LAMP REPLACE
indicator
Screw
Screw
Handle
Lamp
65
Advertisement
Table of Contents
