Lamp Replacement - Sanyo PLC-XF30NL Owner's Manual

CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45
minutes before you open Lamp Cover. Inside
of a projector can become very hot.
Follow these steps to replace lamp assembly.
1 Check number of lamp to be replaced on Lamp Status
Display.
2
Turn off a projector and disconnect AC Power Cord. Allow a
projector to cool for at least 45 minutes.
3 Loosen 3 screws on Lamp Cover and remove Lamp Cover.
(See right figure.)
Loosen 2 screws and pull out Lamp Assembly to be replaced
4
by grasping handle.
5 Replace Lamp Assembly with a new one and tighten 2 screws.
Make sure that Lamp Assembly is set properly
6
Replace Lamp Cover and tighten 3 screws.
Connect AC Power Cord to a projector and turn projector on.
7
Reset Lamp Replacement Counter. (Refer to section "Lamp
8
Counter Reset" on page 41.)
NOTE : Do not reset LAMP REPLACEMENT COUNTER
when lamp is not replaced.
CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY
RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing
all 2 lamps at a time.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give following
information to dealer.
Model No. of your projector
Replacement Lamp Type No. : POA-LMP39

LAMP REPLACEMENT

: PLC-XF30/XF30NL
(Service Parts No. 610 292 4848)
CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.
LAMP
COVER
LAMP 1
LAMP 2
SCREWS
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 2.
APPENDIX
SCREWS
45