Write Data Into The Memory Card - Sanyo PLC-XU10N Owner's Manual

WRITE DATA INTO MEMORY CARD
The data edited by Media Card Imager in the computer can be written in or read from the memory card with the
PC or this projector.
The data edited by Media Card Imager is written in Bit Map type (BMP) or JPEG type (JPG).
If your computer doesn't have the PC card write equipment, the data can be written or read by connecting
with this projector.
NOTE : This operation can be made only by Media Card Imager in PC.
Connect the projector with your computer by the MCI cable
1
(supplied). (Refer to "CONNECTING COMPUTER" on Page 12.)
Insert the memory card into PC CARD SLOT of the projector.
And then, turn on the projector and the computer.
2 Press the MENU button and the ON-SCREEN MENU will appear.
Press the POINT LEFT/RIGHT buttons to select View and press
the SELECT button. Another dialog box VIEW SETTING Menu
will appear.
Press POINT DOWN button and a red arrow appear. Move the
3
arrow to Card access by pressing POINT UP/DOWN button. And
then press SELECT button. "Ready to access" is displayed.
Operate Media Card Imager of PC to write/read the data in the PC
card. (Refer to Owner's Manual of Media Card Imager for
operation.)
NOTE : Connect the projector to the computer with MCI Cable before
turning those appliances on.
Do not press any button while read/write the data through MCI
Cable. Those operations are canceled and the data in the
memory card may be damaged.
Access to the Card with the Projector
Connect the computer and the projector with MCI cable
(supplied) (refer to page 12, 13).
MCI MODE
Move the arrow to
or and press
the SELECT
button.
37