Remote Control Batteries Installation - Sanyo PLC-XU10N Owner's Manual

Sanyo plc-xu10n: owners manual
Table of Contents

Advertisement

Remove the battery
1
compartment lid.
Press the lid
downward and
slide it.
To insure safe operation, please observe the following precautions :
Use (2) AA type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not drop the remote control unit.
If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
Operating Range of the Remote Control
Point the remote control toward the projector (Receiver Window) whenever pressing the buttons. Maximum
operating range for the remote control is about 16.4' (5m) and 60° front and rear of the projector

Remote Control Batteries Installation

Slide the batteries into
2
the compartment.
For correct polarity (+ and –), be sure
the battery terminals are in contact
with the pins in the compartment.
16.4'
(5 m)
60°
BEFORE OPERATION
Replace the compartment
3
lid.
Slide the lid
upward.
16.4'
(5 m)
60°
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plc-xu10

Table of Contents