Table of Contents
Advertisement
Remote Control Code Change and Operating Range
Code Change
This projector has eight different remote control codes (Code 1-Code 8); the
factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).
This switching function prevents remote control interference when operating
several projectors or video equipment at the same time. (Change the remote
control code for the projector first before changing that for the remote control. See
"Remote control" on page 37.)
1
While pressing the MENU button, press the IMAGE button
number of times corresponding to each remote control code
number. Each time you press the IMAGE button, the code is
changed sequentially. (See the list below.)
2
To initialize the remote control code for the remote control,
slide the RESET switch to the RESET, and then to the ON.
The initial code is Code 1.
Number of Times of
Remote Control Code
Pressing IMAGE
Button
Code 1
1
Code 2
2
Code 3
3
Code 4
4
Code 5
5
Code 6
6
Code 7
7
Code 8
8
Remove battery
1
compartment lid.
Press lid down-
ward and slide it.
To insure safe operation, please observe following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at same time.
G Do not use a new battery with an used battery.
G Avoid contact with water or liquid.
G Do not expose Remote Control Unit to moisture, or heat.
G Do not drop Remote Control Unit.
G If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
G Danger of explosion if battery is incorrectly replaced.
G Dispose of used batteries according to the batteries manufacturers instructions and local rules.
ON-OFF
•£
ZOOM
•£
•£
FOCUS
•£
SELECT
RESET
RESET
Remote Control Batteries Installation
Slide batteries into
2
compartment.
Operating Range
Point Remote Control Unit toward
projector
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4'
(5m) and 60° in front and rear of a
projector.
16.4'
(5 m)
MENU button
16.4'
(5 m)
IMAGE button
3
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
BEFORE OPERATION
(Receiver
Window)
60°
60°
Replace compartment lid.
19
Advertisement
Table of Contents
