Parcan 20 Long
Changing the Lamp
01) Disconnect mains power supply. Allow the fixture to cool for at least 15 minutes before handling and
replacing lamp.
02) Read lamp instructions.
03) Follow the directions from page 9.
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, follow the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out the following steps.
If the light effect does not operate properly, refer servicing to a technician.
Suspect two potential problem areas: the power supply and the lamp.
01) Power supply. Check that the unit is plugged into an appropriate power supply.
02) The lamp. Replace the lamp. See page 9 for replacing the lamp.
03) If all appears to be O.K., plug the unit in again.
04) If you are unable to determine the cause of the problem, do not modify the Parcan, as this may
damage the unit and the warranty will become void.
05) Return the device to your Showtec dealer.
Problem
Probable cause(s)
One or more
fixtures do not
No power to the fixture
function at all
Fixture is too hot
No light or lamp
Lamp damaged
cuts out
intermittently
The power supply settings do not
match local AC voltage and
frequency
Ordercode: 30151/30152
Solution
•
Check if power is switched on and
cables are plugged in
•
Allow the fixture to cool down
•
Turn up the air conditioning
•
Disconnect the fixture and
replace the lamp
•
Disconnect fixture. Check settings
and correct if necessary
11