Intellifire Touch ® Control System Setup; Fixed Glass Assembly Removal And Replacement; Install Decorative Barrier Front - Heat&Glo 6KX-CU Installation Manual

H. IntelliFire Touch
• Detailed instructions for electrical wiring and connec-
tions are provided in Section 8.
• Verify that the 3-Position switch on the IFT-ECM is
switched to the REMOTE position. Detailed Operating
Instructions for the IFT-ECM are provided in Section
3.K of the Owner's Manual.
3 POSITION SWITCH
LED INDICATOR
Figure 11.28 IFT-ECM
This appliance is factory-equipped with an IntelliFire®
Touch remote control. The remote was paired to the fire-
place and tested at the factory. It does not need to be
paired again, unless an accessory kit will be added at
the time of installation. If no additional accessory will be
added, simply follow steps one through seven below.
1. If installed, remove batteries from remote.
2. Verify that the new appliance has power and secure
electrical connections.
3. Adjust the ECM selector switch to 'REMOTE' mode.
4. Switch the master reset switch to 'ON' (if equipped).
5. Wait to verify LED indicator on the ECM stops flash-
ing.
6. Install batteries in the RC400 remote.
7. The RC400 remote will automatically pair to the appli-
ance as pre-set at the factory.
Heat & Glo • 6KX, 6KX-LP, 8KX, 8KX-LP Installation Manual • 2583-980 • Rev. C • 5/23
Control System Setup
®
TOP VIEW
I. Fixed Glass Assembly Removal and Re-
placement
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches away from the tabs
on the glass frame. Remove glass assembly from the
appliance. See Figure 11.29.
Replacing Fixed Glass Assembly
• Replace the glass assembly on the appliance. Hold glass
in place with one hand. Use the other hand to pull out
and latch the four glass assembly latches onto the glass
frame tabs.
• Inspect and operate all glass latches to ensure they
move freely and no obstructions are present.
• Reinstall decorative barrier front.
GLASS FRAME
TABS
Figure 11.29 Fixed Glass Assembly
J. Install Decorative Barrier Front
WARNING! Risk of Fire! Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts could cause fireplace to
overheat.
IMPORTANT! This fireplace requires an installed
decorative barrier front to prevent direct contact with
the hot viewing glass. DO NOT operate the fireplace
with the barrier removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
For more information refer to the instructions supplied with
your decorative barrier front.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
85