Install The Burner Overlay; Install The Illuminated Embers - Heat&Glo 6KX-CU Installation Manual

D. Install the Burner Overlay
1. Locate the burner overlay shipped inside the firebox.
2. Remove the burner overlay from the packaging.
Check to ensure all ports are free from any obstruc-
tions. See Figure 11.24.
3. To install the burner overlay, mate the locating holes
with the guide sleeves. Install fiber burner top so that
it makes full contact with the underlying burner assem-
bly. See Figure 11.25.
4. Ensure that the ports in the steel burner are visible
through the holes in the fiber burner top.
BURNER OVERLAY
DETAIL
BLOCKED PORT
PARTIALLY
BLOCKED PORT
Figure 11.24 Check Burner Ports
Heat & Glo • 6KX, 6KX-LP, 8KX, 8KX-LP Installation Manual • 2583-980 • Rev. C • 5/23
78
OPEN PORT
BURNER OVERLAY
BURNER ASSEMBLY
GUIDE SLEEVES
FOR BURNER OVERLAY
BURNER OVERLAY BURNER OVERLAY
Figure 11.25 Burner Overlay Installed
E. Install the Illuminated Embers
Illuminated Embers Placement
1. Pour the provided Stone Media between the left and
right base refractories as shown in Figure 11.26.
ILLUMINATED EMBERS ILLUMINATED EMBERS
Figure 11.26 Illuminated Embers Installed
LOCATING HOLES