Heat&Glo 6100PLUS Owner's Manual

Fresh air fireplace

Advertisement

Quick Links

Models:
6100P LUS
Fresh Air Fireplace
• Important operating and
maintenance instructions
included.
W ARNING
If the information in thes e ins truc-
tions is not fol l owed ex actl y , a
re may res ul t caus ing property
damage, pers onal inj ury , or death.
• Do not store or use gasoline or other am-
mabl e vapors and l i qui d s in the vi c inity of
this or any other appliance.
• W hat to do if y o u sm ell gas:
- Do not try to light any appliance.
- Do not touch any electrical switch. Do not
use any phone in your bui l ding.
- Immediately call your gas supplier from
a neighbor ' s phone. Follow the gas
supplier' s instructions.
- If you cannot reach your gas supplier, call
the re department.
• Installation and servi c e must be performed
by a qual i ed installer, servi c e agency, or
the gas supplier.
Refractory must be ordered separ a tely .
CAUTION
DO NOT DISCARD THIS MANUAL
Read, understand and follow
these instructions for safe
installation and operation.
Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05
Owner' s Manual
Leav e this manual with
party responsible for
use and operation.
W ARNING
HOT! DO NOT TOUCH.
SEVERE BURNS MAY RESUL T .
CLOTHING IGNITION MAY RESUL T .
Glass and other surfaces are hot during
operation and cool down.
Keep children away.
CAREFULLY SUPERVISE children in same room as
appliance.
Alert children and adults to haz ards of high
temperatures.
Do NOT operate with protective barri e rs removed or
door open.
Keep clothing, furniture, draperies and other
combustibles away.
In the Commonwealth of Massachusetts:
installation must be performed by a licensed plumber or gas fi tter.
a CO detector shall be installed in the room where the appliance is
installed.
Installation and service of this appliance should be performed
by qualified personnel. Hearth & Home Technologies
suggests NFI certifi ed or factory-trained
professionals, or technicians supervised
by an NFI certifi ed professional.
Installation and Operation
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6100PLUS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Heat&Glo 6100PLUS

  • Page 1 Installation and service of this appliance should be performed by qualified personnel. Hearth & Home Technologies suggests NFI certifi ed or factory-trained professionals, or technicians supervised by an NFI certifi ed professional. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 2 DO NOT REMOVE OR COVER THIS LABEL. VENTED GAS FIREPLACE - NOT FOR USE WITH SOLID FUEL. FOYER À GAZ À É VACUATION - NE DOIT PAS Ê TRE UTILISÉ AVEC UN COMBUSTIBLE SOLIDE. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 3: Table Of Contents

    Junction Box Instal l ation ..... . 19 Note: An arrow ( ) found in the text si g ni es change in content. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 4: Listing And Code Appr Ovals

    Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 5: Getting Started

    Non-corrosiv e leak check solution 1/2 - 3/4 in. length, #6 or #8 S elf-drilling screws One 1/4 in. female connection (for optional fan). Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 6: Framing And C Lear A Nces

    • Clearances and Mantel Proj ections (Sections 3.C. and 3.D.) • Vent Clearances and Framing (Section 6) 42 in. (1067 mm) 23-1/2 in. (597 mm) Figur e 3.1 Appliance Locations Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 7: Construct The Appliance Chase

    If the appli- ance is bei n g installed on a cement slab, a layer of plywood may be placed underneath to prevent conducting cold up into the room. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 8: Clearances

    Figur e 3.4 Clear a nces to Mantel Legs or W all Projections (A ccept- Figur e 3.3 Clear a nces to Mantels or Other Combustibles Above abl e on both sides of opening) Appliance Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 9: Ermination Locations

    Fai l ure to keep insulation or other materials away from vent pipe may cause re. Note: Refer to the HRV200PLUS installation manual for additional installation and v enting instructions. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 10: Vent Information And Diagrams

    This unit MUST be vented with the HRV200PLUS. • Do not connect to a chimney ue. The 6100PLUS will not v ent correctly unless it is connected to the HRV200PLUS. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 11: Appliance P R Eparation 1

    • Do NOT notch into the framing around the appliance spacers. Fai l ure to keep insulation or other materials away from vent pipe may cause re. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 12: Gas Information

    Minimum Inlet Pressure 5.0 in. w.c. 11.0 in. w.c. Maxi m um Inlet Pressure 7.0 in. w.c. 14.0 in. w.c. Manifold Pressure 3.5 in. w.c. 10.0 in. w.c. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 13: High Altitude Installations

    The 6100PLUS is power vented. High altitude gas appliance considerations are no longer of concern, as long as the gas appliance is properly installed with the HRV200PLUS prop- erly bal a nced (refer to HRV200PLUS manual). Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 14: El Ectrical Information

    Label all wires prior to disconnection when serv icing • Wire must have high temperature controls. Wiring errors can cause improper and dangerous insulation. operation. Verify proper operation after servi c ing. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 15: System Wiring

    This gas appliance requi r es a 110VAC supply to the gas appliance j unction box for operation. A wiring diagram is shown in Fi g ure 8.1. • The 6100PLUS is equi p ped with an intermittent pilot control val v e which operates on a 3 vol t system. See ignition wiring diagram, Fi g ure 8.1. •...
  • Page 16 FIRE Not Used LINE EMBER SOLENOID LED1 PRESS. SW Install Jumper between R2 & 12V. Figur e 8.2 6100P LUS & HRV200P L US Boards Wired T ogether Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 17 Figur e 8.3 Appliance Circuit Board W iring Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 18: Wall Switch

    REM terminals on the control board. A wiring diagram is shown in Fi g ure 8.4. Note: Accessory circulating fans CANNOT be used with the 6100PLUS. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 19: Junction Box Installation

    G R N wire to G R N screw with inside box G R N wire Figur e 8.5 Junction Box Detail Figur e 8.6 Junction Box Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 20: Finishing

    Seal j oints betw een the nished wall and appliance noncombustible material. top and sides using only a 300° F minimum sealant. Figur e 9.3 Noncombustible Facing Diagram Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 21: Appl Iance Setup

    Fi g ure 10.2. Remove the grate. Figur e 10.3 Placing the Lava R Figur e 10.1 /B ox ed Logs Figur e 10.2 Ship ping Location of Gr a te Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 22 You will need to paint the silica rocks with the supplied spray paint to create the most realistic look. See Fi g ures 10.5-10.6. Figur e 10.5 Silic a Rocks Figur e 10.6 Painting the R ocks Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 23: Grate And Log Assembl Y

    Place the left front log in front of the b ack log so the notches rest on the grate. See Fi g ure 10.10. Figur e 10.10 Left Front Log Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 24: 1 Operating Instr U Ctions

    There is a 20 second delay (post-purge). • The HRV200PLUS de-energiz e s C1, turning the ember bed lights off. • The HRV200PLUS ex ecutes a v e-minute low speed post purge. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 25 HRV200PLUS de-energi z es the R1 terminal terminating burner operati o n. • There is a 20 second delay (post-purge). • The HRV200PLUS de-energiz e s C1, turning the ember bed lights off. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 26: Lighting The Appliance

    B. Lighting the Appliance Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 27: After The Appliance Is Lit

    • Keep furniture, draperies away from liqui d s in this appliance. appliance. Combusti b l e materials may ignite. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 28: Troublesh Ooting

    If sooting occurs in the appliance or if combusti b l e material is burned, the pressure switch ports could close and prev ent the appliance from operating. Refer to HRV200PLUS manual. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 29: Maintaining And Servicing The Appl Iance

    Please refer to the HRV200PLUS manual for additional maintenance requi r ements for the venti l ation portion of the Figur e 13.1 Bulb R e placem ent 6100PLUS. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 30 This page intentionally left blank. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 31: Reference Materials

    1-5/8 in. (162 mm) 6 in. 9-1/4 in. (914 mm) (41 mm) (235 mm) (152 mm) 14-3/8 in. 41 in. (365 mm) (104 mm) Figur e 14.1 Appliance Dimensions Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 32: Servi C E Parts List

    This page intentionally left blank. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...
  • Page 33: Limited Lifetime Warranty

    Limited W arranty Hearth & Home T echnologies Inc. (“ H HT” ) ext e nds the following warranty for Heat-N-Glo® 6100PLUS (“ Appliance” ) products installed in homes in the United States of America and Canada. Dealers and employees of HHT have no authority to make any warranty or authoriz e any remedies in addition to or inconsistent with the terms of this warranty.
  • Page 34: Contact Information

    6748942, 6769426, 6774802, 6796302, 6840261, 6848441, 6863064, 6866205, 6869278, 6875012, 6880275, 6908039, 6919884, D320652, D445174, D462436; (Canada) 1297749, 2195264, 2225408, 2313972; (Australia) 780250, 780403, 1418504 or other U.S. and foreign patents pending. Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05...

Table of Contents