Advertisement
Table of Contents
- 1 Remove the Helmet from the Stand and Split It
- 2 Replace the 2X2 White Plate in the Eye with the Lighting Part
- 3 Restore the Lights Back to the Helmet
- 4 Restore the Helmet and Prepare the Stand Base for Spot Lights
- 5 Modify the Base by Detaching and Rearranging Plates
- 6 Assemble the Spot Lights on the Stand and Power Options
- Download this manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Glow Bricks Lego Dark Trooper Helmet 75343
Summary of Contents for Glow Bricks Lego Dark Trooper Helmet 75343
- Page 1 Dark Trooper Helmet...
- Page 2 First of all, remove the helmet from the stand and split it as shown...
- Page 3 Remove the 2x2 white plate from the eye and replace by the lighting part After the installation the led bulb should be at the middle of the eye like the picture below...
- Page 4 After the lights for both eyes are installed, restore them back to the helmet...
- Page 5 Restore the whole helmet then put it back on the stand To assemble the spot lights on the corners of the stand, start by detaching the base and modify it by the plates attached...
- Page 6 Split the base as shown, detach the 1x8s and 1x10s on the side Rearrange the base by putting the 1x8’s at the bottom with one 1x2 plate on each side, the cover the top by the remain 1x2 and the 1x10...
- Page 7 Now you would get 2 extra studs extended from the corner to put the spot lights on Restore the stand and assemble the lights, then you may power it up by either USB or the battery case *Beware, if you powered by power bank with protection it might be turned off by itself due to the power consume is too little, then you need to power by AC adaptor or use the battery...
Need help?
Do you have a question about the Lego Dark Trooper Helmet 75343 and is the answer not in the manual?
Questions and answers