Table of Contents
Advertisement
Unit Knockdown Dimensions
NOTE: Drawings, dimensional values, and other information may change depending on options or configurations selected.
Refer to the as-built submittal drawings provided by a Daikin Applied sales representative for configuration-specific
details.
Figure 21: Unit Dimensional Diagram for Typical WSC/HSC/TSC Knockdown
GG
HH
UNIT KNOCKDOWN
(VESSELS SEPARATED)
NOTES:
1.
IF NO DIMENSION IS LISTED IN THE 'MOUNTED STARTER TABLE' IT IS BECAUSE THE STARTER BRACKETS DO NOT EXCEED
THE ENVELOPE DIMENSIONED IN THE 'ALL UNITS TABLE'.
2.
DIMENSIONS FF, JJ, NN, AND PP DO NOT TAKE INTO ACCOUNT ANY VALVES SUCH AS RELIEF VALVES THAT MAY INCREASE
THE ENVELOPE.
EXPLANATION OF KNOCKDOWN DIMENSIONS:
DD
DD
HEIGHT (BOTTOM OF FOOT TO TOP OF COND TIE PLATE)
EE
OVERALL WIDTH - UNIT (OUTSIDE EDGE OF COND TUBESHEET TO OUTSIDE EDGE OF EVAP TUBESHEET)
FF
OVERALL HEIGHT - UNIT (BOTTOM OF FOOT TO TOP EVAP, EITHER EVAP TUBESHEET OR COMPR BRACKET)
GG
HEIGHT - COND (BOTTOM OF COND, EITHER COND TUBESHEET OR PIPING, TO TOP OF COND TIE PLATE)
HH
WIDTH - COND (OUTSIDE EDGE OF COND TUBESHEET TO OUTSIDE EDGE OF SHUTOFF VALVE)
JJ
HEIGHT - EVAP (BOTTOM OF MOTOR DRAIN LINE TO TOP OF EVAP, EITHER EVAP TUBESHEET OR COMPR BRACKET)
KK
WIDTH - EVAP (OUTSIDE EDGE OF EVAP TIE PLATE TO OUTSIDE EDGE OF EVAP TUBESHEET OR COMPR BRACKET)
LL
HEIGHT - TUBESHEET SUPPORT (BOTTOM OF FOOT TO TOP OF TIE BRACKET)
MM
OVERALL WIDTH - UNIT (OUTSIDE EDGE OF COND TUBESHEET TO OUTSIDE FACE OF STARTER BRACKET)
NN
OVERALL HEIGHT - UNIT (BOTTOM OF FOOT TO TOP EDGE OF TOP STARTER BRACKET ON EVAP)
UNIT KNOCKDOWN
PP
HEIGHT - EVAP (BOTTOM OF MOTOR DRAIN LINE TO TOP EDGE OF TOP STARTER BRACKET)
QQ
WIDTH - EVAP (OUTSIDE EDGE OF EVAP TIE PLATE TO OUTSIDE FACE OF STARTER BRACKET)
IOM 1274-3 • CENTRIFUGAL WATER CHILLERS
QQ
KK
EE
LEFT VIEW
EE
MM
LEFT VIEW
GG
HH
JJ
PP
DD
LL
FF
NN
26
Installation
EE
UNIT KNOCKDOWN
(VESSELS SEPARATED)
LEFT VIEW
EE
MM
UNIT KNOCKDOWN
LEFT VIEW
www.DaikinApplied.com
LL
FF
NN
GG
Advertisement
Table of Contents
