Marantz AV 10 Owner's Manual page 276

Contents Connections
DTS Neural:X mode cannot be selected.
DTS Neural:X cannot be selected when using the headphones.
0
Dolby Surround mode cannot be selected.
Dolby Surround cannot be selected when using the headphones.
0
IMAX DTS:X cannot be selected.
IMAX DTS:X and IMAX DTS cannot be selected but DTS:X and DTS can be selected, when the headphones are used.
0
Sound modes other than "Stereo" or "Direct" cannot be selected.
Only "Stereo" or "Direct" can be selected for the sound mode if Headphone:X signals are input.
0
Audyssey MultEQ ® XT32, Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 139)
0
Audyssey Dynamic EQ , Audyssey Dynamic Volume
®
0
that have "+ Virtual:X" in the sound mode name.
These cannot be selected when using the headphones.
0
"M-DAX" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "M-DAX" cannot be used. (v p. 181)
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 139)
0
Front panel Display
Playback Settings
® , Audyssey Dynamic Volume
® Setup. (v p. 204)
and Audyssey LFC™ cannot be selected when sound mode is "DTS Virtual:X" or sound mode
®
276
Rear panel
Tips
® and Audyssey LFC™ cannot be selected.
Remote Index
Appendix