Advertisement
Contents
Connections
o LPF for LFE
Selects the crossover point for the LFE channel. Set this when you
want to change the playback LFE signal of the subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz (Default: 120 Hz)
0 The audio settings in "IMAX Audio Settings" are applied during IMAX
playback. (v p. 178)
o LFE Distribution
Adjusts the amount of LFE signal sent to the large floor speakers.
Off
(Default):
–20 dB – 0 dB
0 This setting cannot be set when the "Front", "Center", "Surround", "Surround
Back", and "Front Wide" settings of "Speaker Configuration" are all "Small".
Front panel
Display
Playback
Floor Speakers do not play LFE signals.
Adjusts the amount of LFE signal sent to
the large floor speakers.
Rear panel
Settings
Front Speaker
Set the front speaker A/B to use for every sound mode.
A
(Default):
B :
A+B :
0 This can be set when "Assign Mode" is set to "13.1ch + Front B". (v p. 215)
238
Remote
Tips
Appendix
Front speaker A is used.
Front speaker B is used.
Both front speakers A and B are used.
Index
Advertisement
