Download Print this page

Marantz AV 10 Owner's Manual page 275

Av preamplifier
Hide thumbs Also See for AV 10:

Advertisement

Contents
Connections
No sound comes out of a specific speaker.
Check that PRE OUT cables and speaker cables are properly connected.
0
Check that a selection other than "None" is set for the "Speaker Configuration" setting in menu. (v p. 225)
0
Check the "Assign Mode" setting in the menu. (v p. 215)
0
When the sound mode is "Stereo" and "Virtual", audio is only output from the front speakers and subwoofer.
0
Audio is not output from the surround back speaker if "Speaker Virtualizer" is set to "On" when "Speaker Configuration" - "Surround Back" is set to "1
0
spkr" in the menu. (v p. 177)
Audio is not output from the front wide speaker if "Speaker Virtualizer" is set to "On". (v p. 177)
0
When "Speaker Configuration" - "Surround Back" is set to "2 spkrs", "Speaker Configuration" - "Center" is set to "Large" or "Small", and sound mode is
0
set to "IMAX DTS", surround audio is output from the surround back speaker. Audio is not output from the surround speaker. (v p. 230)
No sound is produced from subwoofer.
Check the subwoofer connections.
0
Turn on the subwoofer's power.
0
Set "Speaker Configuration" - "Subwoofer" in the menu to "1 spkr", "2 spkrs", "3 spkrs" or "4 spkrs". (v p. 226)
0
When "Speaker Configuration" - "Front" in the menu is set to "Large", depending on the input signal and the sound mode, no sound may be output from
0
the subwoofer. (v p. 226)
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 237)
0
You can make the subwoofer always output sound by setting the "Subwoofer Output" to "LFE + Main". (v p. 237)
0
DTS sound is not output.
Check that the digital audio output setting on the connected device is set to "DTS".
0
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
Make HDMI connections. (v p. 70)
0
Check the digital audio output setting on the connected device. On some devices, "PCM" is set by default.
0
Front panel
Display
Playback
Settings
275
Rear panel
Tips
Remote
Index
Appendix

Advertisement

loading