Marantz AV 10 Owner's Manual page 198

Av preamplifier

Hide thumbs Also See for AV 10:

Set the video signal format to be output for the TV you are using.

0 "Format" can also be set by the following procedure. However, the menu

screen is not displayed. Following the display content to make the setting.

1. Press and hold the main unit's STATUS and ZONE3 SOURCE at the same

time for at least 3 seconds.

"zVideo Format <NTSC>" appears on the display.

2. Use the main unit's cursor Left or cursor Right and set the video signal

3. Press the main unit's ENTER to complete the setting.

0 When a format other than the video format of the connected TV is set, the

picture will not be displayed properly.

Select NTSC output.

Select PAL output.