Chapter 1 - Non-Nat Ipsec And Routefinder Setup Example; Set Up A Vpn Client Using Ipsec Vpn Client Software And A Routefinder - Multitech RouteFinder RF850 Reference Manual
Ipsec vpn client and the routefinder rf850/rf860 setup examples reference guide
Hide thumbs
Also See for RouteFinder RF850:
- Brochure & specs (8 pages) ,
- Quick start manual (32 pages) ,
- User manual (194 pages)
Advertisement
Chapter 1 – Non-NAT IPSec and
RouteFinder Setup Example
Set Up a VPN Client Using IPSec VPN Client
Software and a RouteFinder
First, in this non-NAT example, set up the VPN client using the IPSec VPN Client software. Then set up
the VPN tunnel for the RouteFinder using the RouteFinder software.
Step 1 – VPN Client Side Set Up (Phase 1)
1.
Open the IPSec VPN Client software.
2.
Right click on RouteFinder Client VPN Configuration and select New Phase 1.
3.
Enter a name for your connection in the Name field.
4.
Choose Any for the client Interface if your IP address is dynamic or the IP address provided
by your ISP if Static (e.g., 65.126.90.250).
5.
In the Remote Gateway field, enter the IP address of the VPN WAN for your Remote
Gateway (e.g., 65.126.90.248).
6.
Enter the Shared Secret in Preshared Key for your network (the Secret has to match on both
ends). Then Confirm the shared secret by retyping the shared secret.
7.
For IKE Authentication choose MD5.
8.
For Key Group choose DH1024.
Multi-Tech Systems, Inc. IPSec VPN and RF850/860 Setup Examples – A Reference Guide (S000433B)
Chapter 1 – Non-NAT IPSec and RouteFinder Setup Example
VPN Client Setup
4
Advertisement
