Install The Faucet; Install System Manifold - Philips AUT3268 User Manual

2. Install the faucet

Note:
Select an appropriate installation position. The environment where the faucet is installed
should adhere to any appropriate hygiene and sanitation conditions.
Make sure the faucet sits �at on top of the sink or countertop surface.
a. Drill a hole with a diameter of about 20 mm.
Skip this step if there is already a hole in the sink or
the countertop surface.
b. Install the faucet according to the diagram.
Screw the faucet stem nut all the way up the faucet
stem, and tighten it to secure the faucet.
c. Connect the faucet cable to the faucet connector in
the back of the system and tighten the nut to secure
the cable.

3. Install system manifold

Note:
Please check if there is sufficient space for installing the system itself, its accessories,
connections, and for servicing and repair. Under no circumstances should the system be
installed outdoors. The environment where the system is installed should adhere to any
appropriate hygiene and sanitation conditions. Avoid any external dripping liquids from
pipes or drains etc. onto the system.
This system should be placed on a stable and �at surface. Keep the system away from heat.
It shall not be placed in a place that may have in�ammable gas leakage.
Wall mounting (optional step)
a. Select an easily accessible area under the sink to mount the system manifold.
b. Take off the cover, mark wall placement for mounting screws using the built-in bracket
on the back of the manifold. Ensure holes are as level as possible. (Note: At least 40cm
from holes to the �oor to allow ample space for �lter replacement)
Quick connect �tting
6
lever
washer
rubber washer
rubber washer
Nut