Install The Faucet - Philips AUT7006 User Manual

d. Connect the cold water hose with the
three-way ball valve and screw it tightly with
a wrench. Please don't miss the gasket in the
cold water hose during installation.
e. Switch off the three-way ball valve. Turn on
the cold water supply. Wipe the connections
with a tissue to see if there is leakage. If the
tissue stays dry, it means the three-way ball
valve is installed properly.

2. Install the faucet

Note:
Select an appropriate installation position. The environment where the faucet is installed
should adhere to any appropriate hygiene and sanitation conditions.
Make sure the faucet sits �at on top of the sink or countertop surface.
a. Drill a hole with a diameter of about 25 mm.
Skip this step if there is already a hole in the sink
or the countertop surface.
b. Install the faucet according to the diagram.
Screw the faucet stem nut all the way up the
faucet stem, and tighten it to secure the faucet.
c. Connect the faucet cable to the faucet connector
in the back of the system and tighten the nut to
secure the cable.
Nut
5
(1)
(2)
Gasket
Hot Cold
(2)
RO �ltered water
Rubber washer
Rubber washer
(1)