Connect The Water Tank With The System; Check If The System Is Installed Properly - Philips AUT3268 User Manual

Filtered water outlet
Note: The inlet water pressure should be within 0.3-0.7 MPa. If the pressure is too low,
a pressure booster should be installed prior to the system. If the pressure is too high,
a pressure relief valve should be installed prior to the system.

7. Connect the water tank with the system

Install the water tank ball valve on the water tank by turning it clockwise.
Cut a section of 1/4" pipe. Insert one end of the pipe into the water tank ball valve, and
insert the other end of the pipe in the water tank connector in the back of the system until
it stops.
8. Check if the system is installed properly, and turn on the three-way ball valve
Tank Drain outlet
Filtered water outlet
Water inlet
Tank Drain outlet
9
Water inlet