Using The System; Before The �Rst-Time Use; Maintenance; Routine Maintenance - Philips AUT3268 User Manual

V. Using the system
1. Before the �rst-time use
a.Turn off the water tank ball valve and turn on the faucet.
b. Check if there is leakage on all the connections.
c. Follow the instructions to �ush thoroughly.
Flush the �lters:
- Turn off the water tank ball valve. Turn on the faucet to let water �ow through the system
for 30 mins.
Flush the water tank
- Turn off the faucet. Turn on the water tank ball valve and let it be �lled with water.
This will take 1-2 hours depending on the inlet water pressure. Once the water tank is full,
the system will stop �ltering water.
- Turn on the faucet and empty the water tank to �ush the water. Once it's empty, turn off
the faucet, and the water tank will be �lled again.
- Repeat the steps above 2 times.
Now the system is ready to use.
Note:
The �ow rate will be less than your kitchen faucet. Water will run to the drain while the RO
�lter system is �ltering water – even when not in use. This is normal.
Water going to drain will stop automatically when the water tank is at capacity.
VI. Maintenance

1. Routine maintenance

- Organic solvent such as gasoline etc. shall not be used for wiping the housing of the
device. If cleaning is required, please gently wipe the surface of the product with a wet
cloth.
- If the system is not used for more than 2 days, turn on the faucet for more than 5 minutes
to �ush the system.
- If the system will not be used for an extended period, take out the �lter cartridges, seal
them with plastic wraps, and store them in the refrigerator (not in the freezer). Turn off
the three-way ball valve, turn on the faucet to empty the water tank, and turn off the
water tank ball valve. Before using it again, repeat step c and step e in chapter V.
11