Install The Faucet - Philips AUT2015 User Manual

d. Connect the cold water hose with the
three-way ball valve and screw it tightly with
a wrench. Please don't miss the gasket in the
cold water hose during installation.
e. Switch off the three-way ball valve. Turn on
the cold water supply. Wipe the connections
with a tissue to see if there is leakage. If the
tissue stays dry, it means the three-way ball
valve is installed properly.

2. Install the faucet

Note:
Select an appropriate installation position. The environment where the faucet is
installed should adhere to any appropriate hygiene and sanitation conditions.
Make sure the faucet sits flat on top of the sink or countertop surface.
a. Drill a hole with a diameter of
about 29mm. Skip this step if
there is already a hole in the sink
or the countertop surface.
b. Install the faucet according to the
diagram. Screw the faucet stem
nuts all the way up the faucet stem,
and tighten them to secure the
faucet with a 14mm socket spanner.
Filtered
water
Nuts
5
(1)
(2)
Gasket
Hot Cold
(2)
RO ltered
water
Base
Rubber washer
Washer
(1)