Table of Contents
Advertisement
Power Supply
The SSG-6029P-E1CR12H/L/T has two redundant, hot-plug, 1200 Watt power supplies. The
power modules are hot-swappable, enabling them to be replaced without powering down the
system.
These power supplies are auto-switching capable, allowing them to automatically sense and
operate at a 100v to 240v input voltage. An amber light will be illuminated on the power
supply when the power is off. An illuminated green light indicates that the power supply is
operating normally.
Replacing a Power Supply Module
1. Determine which power supply module needs to be replaced and unplug the power cord
to that module.
2. Push the release tab (on the back of the power supply), as illustrated, to release the
power module from the chassis.
3. While holding down the release tab, pull the power supply out using the handle provided
on the power module.
4. Replace the failed power module with the same model power supply.
5. Push the new power supply module into the power bay until the tab clicks into the
locked position.
6. Plug the AC power cord back into the module and the replacement power module will
automatically power up.
Release Tab
Figure 3-10. Replacing a Power Supply Module
Chapter 3: Maintenance and Component Installation
44
Advertisement
Table of Contents
