Table of Contents
Advertisement
Figure 107. Installing the BOSS N1 card into the system board
Next steps
Follow the procedure listed in
Removing M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the BOSS N1
NOTE:
The procedure to remove the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Using the Phillips 1 screwdriver, remove the screw securing the M.2 SSD module to the BOSS N1 card.
2. Pull the M.2 SSD module to disconnect from the connector on the BOSS N1 card.
134
Installing and removing system components
After working inside your
Safety
Before working inside your system
card.
system.
instructions.
.
Advertisement
Table of Contents
